The cooling system keeps our engine from overheating while you are driving around Fountain Colorado. Its job is to move heat away from the engine. Let’s talk about the various components of the system and how they work to accomplish this.
The radiator is the part most everyone associates with the cooling system. Coolant flows through the radiator which has fine cooling fins that draw the heat out of the coolant and dissipate it into the air. To make sure there’s enough airflow over the radiator, a fan pulls air over the cooling fins even when the car is idling.
In some vehicles, the fan is powered by the serpentine belt. On others, an electric motor runs the fan. Electric fans turn on and off as needed. You may have heard the fan kick on shortly after you turn your car off. The sensor has determined that the engine needs a little help cooling down to a safe temperature.
A hose connects the radiator to the water pump. The water pump pushes the water into the engine block. Now the engine block and cylinder heads have passages for the coolant to pass through without getting into the oil or the combustion chamber. These passages are referred to as the “water jacket”.
While the coolant is passing through the water jacket, it absorbs heat from the engine on its way to the radiator for cooling. Between the engine and the radiator is a gatekeeper called the thermostat. The thermostat’s job is to regulate the temperature of the engine just like your home thermostat regulates the temperature of your house. It gets your engine up to the correct operating temperature and then keeps it from overheating.
When your first start the engine, it’s very cold and needs to warm up. So the thermostat blocks the flow of coolant to the radiator. As the engine warms up, the thermostat starts to let coolant flow through the system.
The final component I want to talk about is the overflow reservoir. This bottle is designed to hold some of the coolant. It’ll have a mark that indicates whether or not you have enough coolant. This is where you should add coolant if you just need to top it off.
Caution: never open the reservoir or the radiator cap when the car’s hot. The cooling system is pressurized and opening them while it’s hot can cause hot coolant and steam to escape resulting in serious burns.
Cooling system failure is the most common mechanical failure in vehicles around Fountain Colorado. Your Fountain Colorado service center can do a periodic inspection of the components for leaks, loose connections and weakening hoses.
Jackson Automotive LLC
411 Royalty Pl.
Fountain, Colorado 80817
719-393-1317
Your manufacturer has also specified a cooling system service interval. With a cooling system service, the old coolant is replaced with correct clean fluid that contains the additives required to prevent corrosion. The additives are depleted over time and you need fresh fluid for adequate protection. Your radiator pressure cap should be replaced at this service as well.
The cooling system keeps our engine from overheating while you are driving around Fountain Colorado. Its job is to move heat away from the engine. Let’s talk about the various components of the system and how they work to accomplish this.
The radiator is the part most everyone associates with the cooling system. Coolant flows through the radiator which has fine cooling fins that draw the heat out of the coolant and dissipate it into the air. To make sure there’s enough airflow over the radiator, a fan pulls air over the cooling fins even when the car is idling.
In some vehicles, the fan is powered by the serpentine belt. On others, an electric motor runs the fan. Electric fans turn on and off as needed. You may have heard the fan kick on shortly after you turn your car off. The sensor has determined that the engine needs a little help cooling down to a safe temperature.
A hose connects the radiator to the water pump. The water pump pushes the water into the engine block. Now the engine block and cylinder heads have passages for the coolant to pass through without getting into the oil or the combustion chamber. These passages are referred to as the “water jacket”.
While the coolant is passing through the water jacket, it absorbs heat from the engine on its way to the radiator for cooling. Between the engine and the radiator is a gatekeeper called the thermostat. The thermostat’s job is to regulate the temperature of the engine just like your home thermostat regulates the temperature of your house. It gets your engine up to the correct operating temperature and then keeps it from overheating.
When your first start the engine, it’s very cold and needs to warm up. So the thermostat blocks the flow of coolant to the radiator. As the engine warms up, the thermostat starts to let coolant flow through the system.
The final component I want to talk about is the overflow reservoir. This bottle is designed to hold some of the coolant. It’ll have a mark that indicates whether or not you have enough coolant. This is where you should add coolant if you just need to top it off.
Caution: never open the reservoir or the radiator cap when the car’s hot. The cooling system is pressurized and opening them while it’s hot can cause hot coolant and steam to escape resulting in serious burns.
Cooling system failure is the most common mechanical failure in vehicles around Fountain Colorado. Your Fountain Colorado service center can do a periodic inspection of the components for leaks, loose connections and weakening hoses.
Jackson Automotive LLC
411 Royalty Pl.
Fountain, Colorado 80817
719-393-1317
Your manufacturer has also specified a cooling system service interval. With a cooling system service, the old coolant is replaced with correct clean fluid that contains the additives required to prevent corrosion. The additives are depleted over time and you need fresh fluid for adequate protection. Your radiator pressure cap should be replaced at this service as well.
Our cars have to operate in a wide range of Fountain, Colorado temperatures and our engine coolant must be able to perform ‘no matter what’. Think for a moment about the environment where the coolant works. Very hot, high pressure, corrosive…
And all the while, it has to protect the components of the cooling system from corrosion. These components are made from steel and aluminum, plastics and rubber. The coolant has to be formulated to protect against corrosion for all of these different materials. That’s why different manufacturers recommend different types of anti-freeze for our Fountain, Colorado vehicles.
There are several different ‘families’ of anti-freeze available to us here in Fountain, Colorado. Your owners’ manual will tell you what kind you should use. Of course, Jackson Automotive LLC will know what to put in your car.
It’s important to stay on top of this because coolant system failure is the most common mechanical problem people have here in Fountain, Colorado. Regular service at Jackson Automotive LLC needs to be done to avoid failures and also to keep your warranty in place.
While the specifics of the service required may vary from vehicle to vehicle, your service consultant at Jackson Automotive LLC will know what to do. You’ll be advised to replace the coolant at specified intervals.
Some manufacturers may recommend periodic coolant system flushes. A flush adds a cleaning step to the fluid replacement process. Again, check to see what your service consultant recommends.
Someday, you may have to deal with an overheating problem, so you need to know what to do if your coolant temperature warning light comes on or your temperature gauge is in the hot zone.
Now, overheating can be very expensive. You can literally melt down your engine and have to replace the whole thing. So take the warning signs seriously and take immediate steps.
First turn off the air conditioner. This will lower engine temperature right away. Next turn your heater to maximum heat and run the fan at high speed. You might need to roll down the windows, but this will take a lot of heat off the engine.
Pull over as soon as you can safely do so, especially if you are stuck in slow-moving traffic, and shut the car off. It may take as much as 45 minutes for the engine to cool to the point that it’s safe to operate the car again.
If you need to add water or antifreeze, be sure to wait until the car cools down. Opening the radiator cap or even the overflow bottle when the coolant is hot and under pressure may result in serious burns.
So after the engine has cooled for 45 minutes or so, look to see if the coolant is low in the overflow tank. If so, you can cover the overflow tank cap with a large cloth and open the lid. Then start the engine and pour in some water or antifreeze. Pouring it in when the car is running will circulate the new, cool fluid with the warmer fluid in the engine and avoid engine damage.
Of course, overheating is a serious problem and you need to get it fixed right away. Jackson Automotive LLC can make sure the coolant is right before you drive home.
Those spring and winter inspections really come in handy when they head off a cooling system problem. And don’t forget that severe service driving conditions, like towing or hot, dusty driving around Fountain, Colorado, mean that you’ll need to service your coolant more frequently.
At AutoNetTV, we suggest that you have Jackson Automotive LLC inspect your coolant system to find small problems before they become big, and to change belts and hoses before they fail. After all, we don’t want you to lose your cool out there in Fountain, Colorado.
The coolant system is a vital part of your vehicle. It is also the second most common cause for vehicle failures. Even though coolant system failure is fairly common, it is easy to prevent.
The most recognizable part of the coolant system is the radiator. It is connected to the engine with hoses and is filled with coolant. The coolant draws heat off the engine and then goes into the radiator. Air passes through cooling fins to reduce the temperature of the coolant and then it’s back to the engine again.
There are several ways for the cooling system to fail. Most common is with the coolant itself. Coolant is a mixture of water and antifreeze. The proper mixture keeps the coolant from either boiling away or freezing. Both of which can result in massive engine damage.
Another very important coolant issue that is often overlooked is the age of the coolant itself. Antifreeze has additives that protect the coolant system from corrosion. As these additives are depleted over time, they can’t protect the radiator and other parts from rust, scaling and corrosion. Old coolant may still keep your engine cool, but it won’t protect it from corrosion.
If you see a warning message to check the coolant or if the temperature gauge is in the hot zone your cooling system needs to be checked. It’s OK to add water or antifreeze yourself. But you need to be cautious. Remember four things.
- First, you never want to open the radiator pressure cap. You could be severely burned.
- Second, try to get to a Fountain service center such as Jackson Automotive LLC immediately if your coolant is low. If that is not possible, follow the directions in your owners manual – it will direct you to only make additions to the coolant overflow bottle.
- Third, remember that you need a proper mixture of water and antifreeze. If you make an emergency addition to your cooling system, follow-up with your service center where they can make necessary corrections.
- Fourth, not all cars use the same type of antifreeze. You need to check your owners manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. Again, another reason to rely on your Fountain service center to do things right.
Remember, Jackson Automotive LLC has the equipment to change your coolant quickly and inexpensively. 719-393-1317
You may know that most automotive failures are tire related, but do you know the second most common cause for vehicle failure? Nope, it’s not teenagers. It is the coolant system. But, if you take good care of your coolant system, it will take good care of you.
A car’s engine creates a lot of heat – so much heat, that if it is not properly cooled, the engine can lock up, resulting in massive damage and repair bills. But when everything is working right, your engine operates at the proper temperature and all is well. Without antifreeze in your cooling system, the water could freeze and cause engine damage. This could be very expensive, not to mention inconvenient.
The right mix of water and antifreeze protects the engine against damage from freezing and overheating. Antifreeze also protects the coolant system against corrosion that could cause the system to fail. The thing to remember is this: coolant system failure is very common, but it is also very easy to prevent. Service technicians at Jackson Automotive LLC can check the manufacturers’ recommendations, and tell you when the coolant needs to be changed. See http://jackson-automotive.com/?page_id=5. They can also perform a coolant system service.
Even the best antifreeze cannot completely protect the coolant system from harmful deposits forever. The anti-corrosion additives are used up over time, so the coolant must be replaced. A coolant service cleans out the system and replaces the old fluid with fresh coolant. A coolant system service is a low-cost way to protect against major engine repairs down the road. Prevention is the key. Be sure to watch out for the two main warning signs: if your temperature gauge is in the “hot” zone or if you get a message warning you to check your coolant. If you take a look under the hood, you will see the coolant overflow bottle. You can see there are lines that indicate the proper level of coolant … if your engine is cold – or if it is hot.
You can add water or antifreeze to that bottle yourself, but be careful. First, you never want to open the radiator pressure cap. The steam could severely burn you. Second, try to get to your Fort Carson or Security auto service center immediately if your coolant is low. If that is not possible, follow the directions in your owner’s manual. Third, remember that you need a proper mixture of water and antifreeze, or you will damage your engine. If you make an emergency addition to your cooling system, follow-up with your service center where they can make necessary corrections. Fourth, not all cars use the same type of antifreeze. You will need to check your owner’s manual to make sure you use the right kind. Mixing antifreeze types or using the wrong kind of antifreeze may void the manufacturers warranty on your cooling system. If you’re not sure, ask your Colorado Springs area service technician for guidance.
